Rolling bearing judgment method
Home>Bearing knowledge>The method of determining the rolling bearing |
Rolling bearing judgment method
/*250*250 was created on 2017/12/25*/ var cpro_id = 'u3171089'; |
(2) After the bearing of the tapered roller bearing is used, it should be checked whether the rolling body and the inner ring raceway can fall off; whether the frame can be too loose; whether the front and rear margins of the inner ring can be intact; whether the outer ring raceway can have cracks. After the inner ring and roller assembly are installed in the outer ring; the roller should fall into the center of the raceway; the forward displacement does not exceed 1. 5mm. One of them is unqualified; that is, it cannot be used.
(3) Determination of spherical roller bearings and short cylindrical roller bearings The outer ring of these bearings is separable. Under normal conditions; the inner and outer ring raceways and rollers should be free of breaks, pitting and deep wear marks. , adhere to the frame should be no deformation and can gather the roller on the inner ring, the cooperation gap between the inner and outer ring raceway and the roller should not exceed 0. 06mm.
(4) When the thrust ball bearing determines the normal condition; the two raceways should have no falling damage and severe wear; the balls should be free from breakage and pitting, and the frame should be free of deformation; do not touch the two raceway washers; and the balls are firmly gathered Together.
Recommend to friends comments close window
Bearing related knowledge |
Discrimination of bearing damage-contact; investigation; listening to front/rear bearing protection according to FAG bearing service life and reliability requirements Working on NSK bearings View hub type needle roller bearings with seals |
This article links to http://
Please indicate the bearing network http://
Previous: Bearings common sense: "rolling bearing data" detailed discussion of the following: KOYO bearing failure view method analysis
Polyester Geogrid
Warp Knitted Polyester Geogrid is made of high-tenacity, multifilament polyester yarns and then coated with durable polymer(SBR or PVC) which can provide best resistance of UV and durability. PET Geogrid provides wide strength range of GG-Series with high quality advantages-high tensile modulus and low creep behaviors. PVC Coated Polyester Geogrid successfully offer the stability to earth structures, such as reinforced retaining wall or steep slope, road, bridge or pavement construction.
Applications
Base reinforcement
Subgrade reinforcement
Slope reinforcement
Embankment stabilization
Specification: 20x20kn/m-1000x1000kn/m
Polyester Geogrid
Warp Knitted Polyester Geogrid,PET Geogrid,PVC Coated Polyester Geogrid,Polyester Biaxial Geogrid
Yangzhou Jiangdu Chenguang Special Equipment Factory , http://www.siliconebakingmats.com